![]() ![]() Then unquash the LMDE image into /mnt, install any required packages, and use your old /etc/fstab and /etc/cryptab files in the new system. I think it will be a matter of formatting (or just erasing) your old root partition and mounting your file systems in /mnt just as they are under Mint 10. Can you post your /etc/fstab and /etc/crypttab and the output of 'sudo sfdisk -l' and 'sudo lvdisplay' (if you are using LVM). maybe not straight you'll need to take a slight detour.īut it is hard to come up with that detour without more information. Just boot into the LMDE Live DVD, skip the partition setup, and go straight to Volume Population. If you want to keep the setup you have but with Mint Debian instead of Mint 10, your work is half over (maybe more). I posted this howto both as a reminder to myself (because I forgot some things the last time ) and to help others out. I've used both the encrypted and unencrypted methods at work. Thanks for the positive feedback kwatson512. Also, it is a good idea to remember your password. The following commands just use the defaults. It is also your responsibility to research what encryption algorithms and key sizes are right for you. If you choose to encrypt, it is considered best practice to first fill the partition with randomness to defeat certain key recovery techniques. Code blocks that differ based on this decision are labeled. Now you must make a decision: to encrypt or not to encrypt. If your devices differ, be sure to use your devices in the commands below. In my example, the two partition devices are /dev/sda1 and /dev/sda2. Then create an unformatted partition using the remainder of the disk. Create a new 200MB ext2 primary partition at the start of the disk. In gparted, I just create a new msdos partition table (in the Device menu) which will remove existing partitions. It is up to you to be sure you are using the appropriate drive. But yours may be /dev/hda or something else. You need superuser privileges for everything, so make life easier by getting a root shell.Īgain, my hard drive device is /dev/sda. Once you are sure all your data is safe, put the LMDE DVD in the computer and boot the LMDE live image. This process will destroy everything on the disk. Finally, you will chroot into the environment and fixup the system for first boot.īegin by backing up all your important data. Then you will mount the volumes and extract the Live DVD image into them. Next, you will partition the drive, with optional encryption, and create and partition the volumes. The procedure varies slightly for encryption, so be sure to watch for those deviations.įirst, you will boot the computer using the Linux Mint Debian Edition Live DVD and install some required tools. ![]() The LVM partition may optionally be encrypted. The hard drive will have two primary partitions: a 200MB boot partition (/boot) and an LVM partition that fills the remainder of the drive. This example uses a computer with 2GB of RAM and a 50GB hard drive corresponding to /dev/sda. It is expected that those following this guide are comfortable entering commands in a terminal. This guide will explain how to install LMDE using nothing but a single install medium (LiveCD, LiveDVD, or LiveUSB) and a network connection. Several guides are available for installing Linux Mint Debian Edition on an encrypted LVM file system. Please be sure to backup important data to external media before proceeding. Warning - The procedure outlined in this document is for installing a clean version of Linux Mint Debian Edition using the entire hard drive. ![]() Since this tutorial was written, the install process has evolved, and code has been written to automate the process. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |